All of our infrared heating panels come with fixing kits!
The back of each panel looks like the picture above (this one is a 60cm * 60cm panel).
Inside the box is a template for ease of determining where the holes go on the wall or ceiling!
The fixings provided assume that the panel will be fixed to brick or concrete, so if you are fixing to plasterboard, or a hollow wall, or some other surface then you MUST ensure that you buy the appropriate fixings. These will be available from most reputable DIY stores.
Drill the holes, tap in the fixings, screw into the fixing the screw as supplied or as recommended by the fixing type chosen by you, ensuring that the spacers as supplied are fixed (these ensure that there is a slight gap behind the panel to allow for air circulation) to the panel.
The four crosses on the back of the panel should be presented to the four screws and slid sideways by a few millimeters to fix to the wall or ceiling!
To find out more please check out our website www.multiheat-infrared-heating.co.uk
Thank you!
No comments:
Post a Comment